3.8-1.2とは 意味・読み方・使い方

In this case, the solder alloy comprises more than 3.8 mass% and 4.2 mass% or less Ag, 0.8-1.2 mass% Cu and the balance substantially Sn.例文帳に追加

このときのはんだ合金は、Ag:3.8質量％超4.2 質量％以下、Cu:0.8〜1.2 質量％、残部実質上Snからなる。 - 特許庁

HS≤0.3 H, GR=(2.2 to 3.8) GH, G_r=(0.8 to 2.4) GH, GQ=(1.5 to 2.5) GH, G_q=(0.3 to 1.2) GH.例文帳に追加

Ｈ_S ≦０．３Ｈ、Ｇ_R ＝（２．２〜３．８）Ｇ_H 、Ｇ_r ＝（０．８〜２．４）Ｇ_H 、Ｇ_Q ＝（１．５〜２．５）Ｇ_H 、Ｇ_q ＝（０．３〜１．２）Ｇ_H 。 - 特許庁

The ratio of the width of the second slit to the width of the first slit lies within a range of 1.2 to 3.8.例文帳に追加

第１のスリットの幅に対する第２のスリットの幅の比は１．２と３．８との間にある。 - 特許庁

In soldering by the reflow method using Sn-Ag-Cu based Pb-free Sn solder alloy, the concentration of Ag is controlled to more than 3.8 mass% to 4.2 mass% or less and that of Cu is controlled to 0.8 to 1.2 mass% during soldering in the solder bath.例文帳に追加

Sn-Ag-Cu系の鉛フリーSn基はんだ合金を用いてリフロー法ではんだ付けをする際に、はんだ浴のAg濃度を3.8 質量％超4.2 質量％以下、Cu濃度を0.8 〜1.2 質量％に管理しながらはんだ付けを行う。 - 特許庁

In soldering by the reflow method using Sn-Ag-Cu based Pb-free Sn solder alloy, the concentration of Ag is controlled to more than 3.8 mass% and 4.2 mass% or less and that of Cu is controlled to 0.8-1.2 mass% during soldering in the solder bath.例文帳に追加

Sn-Ag-Cu系の鉛フリーSn基はんだ合金を用いてリフロー法ではんだ付けをする際に、はんだ浴のAg濃度を3.8 質量％超4.2 質量％以下、Cu濃度を0.8 〜1.2 質量％に管理しながらはんだ付けを行う。 - 特許庁

It is Yokoana-shiki sekishitsu (a stone chamber with a laterally attached entrance corridor) with three rooms: Sendo-bu (a passageway leading to the "zenshitsu") (about 1.6 meters in length and 1.2 meters in width), zenshitsu (a small room adjoining the "genshitsu") (about 2.3 meters in length and 1.7 meters in width), and genshitsu (a room where coffins and the dead were laid) (about 3.8 meters in length and 3 meters in width).発音を聞く 例文帳に追加

羨道部（長さ約1.6m、幅1.2m）・前室（長さ約2.3m、幅1.7m）・玄室（長さ約3.8m、幅3m）の三室からなっている横穴式石室である。 - Wikipedia日英京都関連文書対訳コーパス

Then, the elastic body 3 is composed of an olefine resin having an elastic modulus in 100% elongation of 1.2 MPa or more and 7.0 MPa or less and a repeat compression permanent set of 0.9% or more and 3.8% or less.例文帳に追加

そして、この弾性体３を、１００％伸び時での弾性率が１．２ＭＰａ以上７．０ＭＰａ以下であり、繰返し圧縮永久ひずみが０．９％以上３．８％以下であるオレフィン系樹脂で構成する。 - 特許庁