attenuation distortionとは 意味・読み方・使い方

To provide a variable attenuation circuit that exhibits only small waveform distortions and intermodulation distortion and that is superior in electric power resistance.例文帳に追加

波形歪みや相互変調歪みが小さく、耐電力に優れた可変減衰回路を提供する。 - 特許庁

To provide contactless and proximity connections small in signal distortion and attenuation between elements in an electronics system.例文帳に追加

電子工学システム要素間において、信号歪みが小さく、減衰の少ない無接点近接接続を実現する。 - 特許庁

To reduce waveform distortion due to attenuation without requiring the improvement of a transmission line and the addition of a specific circuit or the like.例文帳に追加

伝送線路の改善や特別の回路等の追加を必要とせずに減衰による波形歪みを低減する。 - 特許庁

In a mixer 104 which has the gain increased to increase the distortion at a low temperature, the increase in distortion of IM (Inter Modulation) 3 can be prevented by increasing the attenuation factor at a low temperature.例文帳に追加

低温でゲインが増大して歪みが大きくなるミキサ１０４では、低温で減衰率を増加させることで、ＩＭ３の歪みの増大を防止することができる。 - 特許庁

With this configuration, since the frequency dependency of the distortion compensation quantity by the distortion compensation bias circuit 4 and the frequency dependency of the distortion quantity by the non-linear attenuation circuit 15 suppress with each other, signals can be amplified in a low distortion over wide frequency bands.例文帳に追加

したがって、歪補償バイアス回路４による歪補償量の周波数依存性と非線形減衰回路１５による歪補償量の周波数依存性とが互いに抑制し合うので、広い周波数帯にわたって低歪にて信号を増幅できる。 - 特許庁

To enable making attenuation characteristics in the band flat at arbitrary attenuation level, and obtain good reception level by equalizing signal output level and reducing distortion obstacle generated by changing of the received field strength.例文帳に追加

減衰帯域を任意の減衰レベルで平坦にでき、信号出力レベルを平準化して受信電界強度の強弱による歪障害を軽減し、良好な受信レベルを得る。 - 特許庁

A controller 18 obtains distortion due to an attenuation characteristic of the transmission line 14 from the difference between them and instructs an output adjustment circuit 12 to compensate a transmission signal in response to the distortion.例文帳に追加

コントローラ１８は、その電位差から伝送線路１４の減衰特性による歪み量を求め、その歪み量に応じて送信信号を補償するように出力調整回路１２に指示する。 - 特許庁

In parallel with the measurement, when one distortion rate is a predetermined threshold or higher, an induction supporting section 291 prompts a user to increase the output volume level of the external device until both distortion rates become the threshold or higher while maintaining an attenuation factor difference until both distortion rates become less than the threshold and while performing setting to increase both attenuation factors.例文帳に追加

この計測と並行して、誘導支援部２９１は、一方の歪率が所定の閾値以上である場合は、双方の歪率が閾値未満となるまで減衰率差を維持しつつ、双方の減衰率を増加させる設定を行いつつ、双方の歪率が閾値以上となるまで、利用者に対して外部機器の出力音量レベルを大きくするように促す。 - 特許庁