例文 (307件) |
connection intervalの部分一致の例文一覧と使い方
該当件数 : 307件
To provide a broadband DC component eliminating circuit wherein a high frequency capacitor and a low frequency capacitor are connected in parallel between board patterns opposed to each other with an interval on a dielectric board and a structure realizing ease of mount is realized by decreasing a connection length of metallic conductors such as a gold ribbon and a gold wire incurring deterioration in the high frequency characteristic and to provide an assembling method therefor.例文帳に追加
誘電体基板上で間隔を置いて向き合った基板パターン間に、高周波用コンデンサと低周波用コンデンサを並列に接続した広帯域直流成分除去回路及びその組立方法において、高周波特性の劣化を招く金リボンや金ワイヤーなどの金属導体の接続長を短縮して、実装が容易な構造を実現する。 - 特許庁
After operation pressure in a pressure medium connection circuit is lower than bias pressure previously determined by designing of the pressure medium accumulator, a controller drives a drive unit of a pressure generator, and signal lapse of a measuring device is recorded by the controller over time interval previously determined from the driving of a pressure generator and is compared with a target lapse stored in the controller.例文帳に追加
圧力媒体回路における作動圧力が圧力媒体アキュムレータの設計によって予め決められているバイアス圧力を下回った後圧力生成器の駆動ユニットのドライブを制御装置によって行い、圧力生成器のドライブから前以て決められている時間間隔にわたって、測定装置の信号経過を制御装置によって記録しかつ制御装置に記憶されている目標経過と比較する。 - 特許庁
In the exercise apparatus which is constituted to make the exercising person perform pedaling exercise while sitting on the chair 2 in an attitude of leaning against the backrest, a main body 3 and the chair 2 are connected by a connection means 4 so that an interval between them can be adjusted, and a display panel 14 displaying exercise information is fitted to a bendable support arm 12 erected at the main body 3.例文帳に追加
運動者が背凭れに凭れた姿勢で椅子2に着座して本体3のペダル11に脚を掛けてペダル漕ぎ運動を行うように構成された運動器具において、本体3と椅子2は相互間隔が調整可能なように連結手段4により連結されており、運動情報を表示する表示パネル14は、本体3に立設された折曲自在な支持アーム12に取り付けられる。 - 特許庁
When receiving an access request from a user terminal 20, a TSA-gateway device (time stamp issuance acceptance device) 10 determines whether or not to accept the access request according to the user's access request acceptance interval and the number of allowable simultaneous connections, and if the determination accepts the access request, establishes communication connection between a time stamp issuing device 60 and the access requesting user terminal.例文帳に追加
TSA−ゲートウェイ装置(タイムスタンプ発行受付装置)10が、ユーザ端末20からのアクセス要求受信により、当該ユーザのアクセス要求受け付け間隔及び同時接続可能数に基づいて当該アクセス要求を受け付けるか否かを判定し、この判定の結果、受け付けられたアクセス要求に応じてタイムスタンプ発行装置60と当該アクセス要求元のユーザ端末との通信接続を行う。 - 特許庁
A laser type displacement sensor 9 is installed on the side face of the flywheel 3 with a small interval, the displacement amount oscillating in the axial direction during disconnection and the displacement amount oscillating in the axial direction during connection of the clutch 7 are measured, and numerical values digitally displayed by a display device 10 are read and compared.例文帳に追加
フライホイール3に備えられたクラッチ7の非接続時には、フライホイール3のみが回転し、入力軸2は回転しない状態にあり、フライホイール3に備えられたクラッチ7の接続時には、フライホイール3と共に入力軸2が回転する機構のものおいて、フライホイール3の側面に少し間隔をあけてレーザー式変位センサー9を設置し、クラッチ7の非接続時に軸方向に振れる変位量と、接続時に軸方向へ振れる変位量とを測定し、表示装置10でデジタル表示した数値を読み取り比較する挙動監視装置である。 - 特許庁
To the upper surface at the middle part of the connection plate 8 used only in the advance converting time, a handle 9 for rising holding purpose in order to maintain the parallel condition of the left and the right wheels is installed to the grip of a car body handle 2, by taking an interval.例文帳に追加
自在車輪の回転板に間隔をとつて平行に取り付けた左右案内板の中間を、進行切替え時に車輪取り付け部が案内板にそつて所定範囲内をスライドする構造の自在車輪にして、進行切替え時に左右車輪の平行を保持さすために、自在車輪の車軸取付け板に延長したアームを平行にして両先端が回動するよう繋ぎ板を設けて、進行切替え持のみ使用する繋ぎ板の中間上面に左右車輪の平行を保持さすための、立ち上がりの保持用ハンドルを車体ハンドルの握り部に間隔をとり平行に取り付ける構造とする。 - 特許庁
The sensor also includes a biasing means for biasing the interval between the impeller and the damping impeller to a separating direction, and a connection mechanism for connecting the impeller to the damping impeller, and rotating both impellers at an equal speed, when the impeller approaches the damping impeller up to a prescribed distance against a biasing force by the biasing means.例文帳に追加
羽根車を流れ方向に対して移動自在に設けると共に、流体の流れを受け、羽根車を下流側に移動させる流体受け部を羽根車に設け、羽根車の下流側に、流体の流れによって流れ方向に移動することなく回転する制動羽根車を設け、かつ、羽根車と制動羽根車との間を離間させる方向に付勢する付勢手段と、この付勢手段による付勢力に抗して羽根車が制動羽根車に所定距離まで近づいた場合に、羽根車と制動羽根車とを連結させて両羽根車を等速で回転させる連結機構を設けた。 - 特許庁
例文 (307件) |
Copyright © Japan Patent office. All Rights Reserved. |
ログイン |
Weblio会員(無料)になると
|
ログイン |
Weblio会員(無料)になると
|