意味 | 例文 (23件) |
loss on ignitionの部分一致の例文一覧と使い方
該当件数 : 23件
The amount of heat loss of an internal combustion engine is calculated and the ignition timing is controlled based on the amount of heat loss.例文帳に追加
内燃機関の熱損失量を算出し、熱損失量に基づいて点火時期を制御する。 - 特許庁
The basic ignition timing is corrected on the basis of variation in the amount of loss with respect to a basic loss value which is determined in accordance with the basic ignition timing.例文帳に追加
前記基本点火時期に応じて定めた基本損失値に対する前記損失量の変化量に基づいて前記基本点火時期を補正する。 - 特許庁
At least either the amount of exhaustion loss or the amount of cooling loss based on the basic ignition timing is calculated.例文帳に追加
前記基本点火時期で点火した場合の排気損失量および冷却損失量の少なくとも一方の損失量を算出する。 - 特許庁
To prevent poor combustion from being caused by extinction of flame, ignition on a wall face or around the wall face due to heat loss of an electrode of an ignition plug, or the like.例文帳に追加
点火プラグの電極における熱損失等により、火炎が消滅したり、また、壁面上、又は壁面付近で点火が発生することにより、燃焼不良を生ずることを防止する。 - 特許庁
To provide an ignition coil that can secure an output voltage on its secondary side and has an outer peripheral core having a small eddy-current loss.例文帳に追加
二次側の出力電圧を確保することができ、かつ渦電流損の少ない外周コアを持つ点火コイルを提供することを課題とする。 - 特許庁
In the mold powder for continuously casting a steel, the mass ratio of CaO/SiO_2 is 1.50 to 2.50, and Loss on Ignition (LOI) lies in the range of 15 to 35 mass%.例文帳に追加
本発明の鋼の連続鋳造用モールドパウダーは、CaO/SiO_2質量比が1.50〜2.50で、加熱質量減少(LOI)が15〜35質量%の範囲内にあることを特徴とする。 - 特許庁
In the mixing step, the talc used as the raw material of cordierite has an IgLoss (loss on ignition) of 5.7-6.5 wt.%, determined by heating at 1,000°C for 2 hr.例文帳に追加
混合工程において、コーディエライトの原料として用いるタルクは、加熱温度1000℃、加熱時間2時間の条件で求めたIgLoss(強熱減量)が5.7〜6.5重量%である。 - 特許庁
An engine controller 31 executes a combustion pressure maximum crank angle calculation processing procedure of calculating a crank angle of becoming maximum in combustion pressure on the basis of a loss in the engine and a basic ignition timing calculation processing procedure of calculating the basic ignition timing for providing the MBT on the basis of the crank angle of becoming maximum in this combustion pressure.例文帳に追加
燃焼圧が最大となるクランク角を、エンジンの損失に基づいて算出する燃焼圧最大クランク角算出処理手順と、この燃焼圧が最大となるクランク角に基づいてMBTの得られる基本点火時期を算出する基本点火時期算出処理手順とをエンジンコントローラ(31)が実行する。 - 特許庁
To remarkably reduce an exhaust amount of a combustion exhaust gas and to enable lowering of a harmful gas concentration in the exhaust gas and reducing of loss on ignition of a combustion residue in a stoker type refuse incinerator.例文帳に追加
ストーカ式ごみ焼却炉に於いて、燃焼排ガスの排出量を大幅に減少させると共に、排ガス内の有害ガス濃度の引下げ及び燃焼残渣の熱灼減量の減少を可能にする。 - 特許庁
The phosphorus component capturing agent is based on a magnesia cement composition having the specific magnesium content obtained by reacting magnesium oxide with magnesium chloride under limited conditions, chlorine content and loss on ignition.例文帳に追加
酸化マグネシュウムと塩化マグネシュウムから限定された条件で反応させた特定のマグネシュウム含有量、塩素含有量及び灼熱減量を有するマグネシアセメント組成物を主成分とするリン成分の捕捉剤及びその製造方法。 - 特許庁
A raw material comprising a cerium-based rare earth carbonate and a cerium-based rare earth oxide as components, and having an ignition loss of 0.5-25% based on dry weight loss on heating at 1,000°C for one hour, is used for manufacturing a cerium-containing abrasive.例文帳に追加
セリウム系研摩材の製造に用いられる原料であって、セリウム系希土類炭酸塩およびセリウム系希土類酸化物を主成分として含んでなり、1000℃で1時間加熱した場合の強熱減量が乾燥重量基準で0.5〜25%である、セリウム系研摩材用原料により、上記課題を解決する。 - 特許庁
The polypropylene resin composition contains 100 pts.mass propylene polymer (A) and 0.01-0.5 pt.mass alumina (B) based on transition alumina having an average particle diameter of 0.01-30 μm and an ignition loss of 4-8%.例文帳に追加
プロピレン系重合体(A)100質量部と、平均粒子径が0.01〜30μmであり、かつ、強熱減量が4〜8%である遷移アルミナを主成分とするアルミナ(B)0.01〜0.5質量部と、を含有した。 - 特許庁
To prevent self-ignition combustion of exhaust particulates collected on an exhaust particulate filter and also the dissolution loss or fracture of the filter, when an exhaust temperature is higher than a prescribed one and an engine is in a speed-reducing operation state.例文帳に追加
排気温度が所定値以上であつて機関が減速運転状態の時、排気微粒子フイルタに捕集された排気微粒子の自己着火燃焼と排気微粒子フイルタの溶損や破損を防止する。 - 特許庁
Loss on ignition at 1,000°C for 1 hr is preferably <±2% of the theoretical value (%) and the average particle diameter of secondary particles obtained by the agglomeration of the crystallites is preferably 0.1-2 μm.例文帳に追加
1000℃、1時間の灼熱減量が理論値%の±2%以内であること、および上記結晶子が凝集して得られた二次粒子の平均粒径が0.1μm以上2μm以下であることが好ましい。 - 特許庁
In the method for producing zirconium oxide powder, hydrated zirconia having a BET (Brunauer-Emett-Teller) specific surface area of 100 to 250 m^2/g and the ratio of loss on ignition of 5 to 20% is fired in an atmosphere comprising a hydrogen halide gas.例文帳に追加
BET比表面積が100m^2/g以上250m^2/g以下で、かつ強熱減量割合が5%以上20%以下である水和ジルコニアを、ハロゲン化水素ガスを含有する雰囲気中で焼成する酸化ジルコニウム粉末の製造方法。 - 特許庁
When the fuel injection and ignition are started based on the driving demand of the engine 11 and the engine is restarted, the compression necessary for starting the engine is generated in the cylinders except for the cylinders reducing the pump loss so that the restart of the engine 11 is quickly performed.例文帳に追加
また、エンジン11の駆動要求に基づく燃料噴射及び点火が開始されてエンジン再始動が開始されるときには、上記ポンプロスが低減される気筒以外の気筒でエンジン始動に必要なコンプレッションが生じているため、エンジン11の再始動が速やかに行われる。 - 特許庁
This cemented chip board consists of cement, wood chips and vermiculite having a 0.5-5.0 mm average particle size, a 32-40% SiO2 content and a 9-16 wt.% ignition loss, wherein the vermiculite content in the resulting cemented chip board is 0.5-10 wt.% on the basis of the weight of the board.例文帳に追加
セメント、木片および平均粒径0.5〜5.0mm、SiO_2 含有率32〜40%、強熱減量9〜16重量%であるバーミキュライトからなる木片セメント板であって、前記バーミキュライトの含有量が得られた木片セメント板の0.5〜10重量%であることを特徴とする。 - 特許庁
Moreover, the electronic control unit 56 adds the pumping loss torque to the target torque required for the engine 11, and controls parameters (intake air amount, fuel injection amount, ignition timing etc.) affecting the output torque of the engine 11, based on the target torque after the addition (final target torque).例文帳に追加
さらに、エンジン11に要求される目標トルクに、少なくとも上記ポンピングロストルクを加算し、その加算後の目標トルク(最終目標トルク)に基づき、エンジン11の出力トルクに影響を及ぼすパラメータ(吸入空気量、燃料噴射量、点火時期等)を制御する。 - 特許庁
As compared with the formula of known raw slurry for fiberglass yarn, this slurry composition containing the cracking agent facilitates improving desizing efficiency of fiberglass fabric, lowering the required temperature for the second desizing process, shortening desizing time, reducing the loss on ignition, and enhancing the strength of the fiberglass fabric.例文帳に追加
ガラス繊維ヤーン用の既知の原スラリーの組成と比較して、クラック剤を含有する本スラリー組成物は、ガラス繊維布の糊抜き効率を改善すること、第2糊抜きプロセスに必要な温度を下げること、糊抜き時間を短縮すること、強熱減量を低減すること、及びガラス繊維布の強度を向上させることを可能にする。 - 特許庁
The ink jet recording medium comprises one or more ink absorption layers provided on a support in such a manner that at least one layer contains a mesoporous substance made of a crystalline metal oxide having a mean particle size measured by a dynamic light scattering method of 10 to 200 nm, and an ignition loss of 20% or less.例文帳に追加
支持体上に一層以上のインク吸収層を設けたインクジェット記録媒体において、該インク吸収層の少なくとも一層は動的光散乱法によって測定される平均粒子径が10〜200nmで、強熱減量が20%以下である結晶性の金属酸化物からなるメソポーラス物質を含むことを特徴とするインクジェット記録体。 - 特許庁
The soil-based paving premixture constitutes a soil-based surface layer for finishing a road surface by being mixed with weathered granite powder having the composition of 7-17 mass% Al2O3, 2-10 mass% alkali metal oxide or/and alkaline earth metal oxide, 1-6 mass% ignition loss and the balance substantially SiO2 and being applied on a roadbed 1.例文帳に追加
Al_2O_3が7〜17質量%、アルカリ金属酸化物又は/及びアルカリ土類金属酸化物が2〜10質量%、灼熱減量が1〜6質量%、SiO_2が実質残部の組成を有する風化した花崗岩の粉末と混合され、路床1上に施工されて、路面を仕上げる土系の表層を構成する土系舗装用プレミックスチャである。 - 特許庁
意味 | 例文 (23件) |
ログイン |
Weblio会員(無料)になると
|
ログイン |
Weblio会員(無料)になると
|